The CyberData SIP Paging Adapter is a VoIP endpoint that interfaces analog paging systems with SIP and Multicast-based audio sources. The SPA (SIP Paging Adapter) can be configured to support two separate SIP extensions. SIP extension one passes audio through to the analog output spoken from the caller's handset. When called, SIP extension two plays a bell audio that can be used as a night ringer when configured in a night ring group. The SPA supports up to 9 user-loadable messages that can be played by a DTMF command. The SPA supports a line-In input for playing MOH.
Two SIP extensions (Note: One of these extensions is a dedicated "night ringer," which is not capable of answering a call, and will only play a stored message while the call is ringing.)
Voice prompt pass code and page control
9 user-uploadable page messages
10 channel prioritized Multicast ports
Page to Polycom phones
HTTP Web Interface and setup
G711 A-Law and u-Law, G.722 codecs
10k Ohm input for background music
600 Ohm Balanced audio out
Remote amp fault sensor
DTMF and programmatic controlled Relay
Delayed page support
10/100 802.3af PoE, Optional Power Adapter is not included
- Viking universal paging interface- Select: FXO (loop start) FXS (ring trip) or paging port (VOX relay) interface mode- No power supply required in FXS interface mode- Up to 6 units can be powered from one adapter in the FXO or VOX mode- 30V DC talk battery for interfacing with FXO or unused phone system line input/trunk port- Floating 600 ohm paging output with volume control- Normally open or closed relay for external paging amp activation or interfacing the paging amp with an external background music source- 800 Hz pre-announce page tone (on/off)- Compatible with 24 to 48 volt FXS operation- Calling party control (CPC) detection for immediate disconnect- Busy signal detect disconnect- 2.5 to 5 second VOX silence disconnect timer- Programmable VOX trigger sensitivity- 16 or 36 second default disconnect timer- Screw terminal block connections- Wall mount housing: (2) #6x3/4 panhead screws included - Power: 12-24V DC @ 100mA 120V AC/12V DC @ 500mA UL listed adapter included (not required in FXS mode)- Dimensions: 111mm x 76mm x 36mm (4.38� x 2.97� x 1.38�)- Shipping Weight: .48 kg (1.06 lbs)- Environmental: 0�C to 32�C (32�F to 90�F) with 5% to 95% non-condensing humidity- Relay Contacts: 30V [email protected] 110V [email protected] 125V [email protected] VOX Minimum Audio Signal to Activate Re...
Algo 8301 IP Voice Paging Adapter & Bell Scheduler
IP Paging Adapter for traditional analog amplifiers. The 8301 is a PoE IP Paging Adapter for integrating existing and traditional paging solutions into a VoIP environment, whether premise or hosted. Features include G.722 wideband support with isolated and balanced line output for optimum clarity and intelligibility without hum or noise. To the network side, the 8301 is a SIP endpoint for easy integration with an IP telephone system and easily configured using the intuitive web interface or provisioning capabilities. On the paging side, the 8301 provides balanced audio output using both an XLR connector and included terminal blocks for easy connection to an amplifier, along with a dry contact closure if required by the amplifier. Further speech enhancement is provided by automatic level control, choice of frequency masks, and optional speech compression. Output level is compatible with consumer, commercial, and pro-audio amplifiers requiring either -10 dBm, 0 dBm, or +4 dBu line level. An audio input (also balanced and isolated to prevent equipment ground loops) can be used for auxiliary input or insertion of the 8301 between existing equipment. This allows IP based paging or emergency notification to take control of the amplifier as necessary. Multicast capability allows scalabi...
Cyberdata 011394 SIP Speaker Signal White RAL 9003
The SIP Speaker is a Power-over-Ethernet (PoE 802.3af/802.3at) and Voice-over-IP (VoIP) public address indoor speaker that easily connects into existing local area networks with a single CAT5/CAT6 cable connection. The speaker is compatible with most IP PBX servers. In a non-SIP environment, the speaker is capable of playing audio from a multicast source. Its small footprint and low height allows the speaker to be discreetly mounted almost anywhere. CyberData has maintained one of the most comprehensive list of IP PBX servers certified to work with CyberData VoIP Products.
The Algo 8373 is a PoE IP Zone Paging Adapter for integrating legacy voice paging systems such as an analog paging system into a hosted or premise UC VoIP environment as a third party SIP endpoint. The Algo 8373 eliminates the need for a legacy zone controller. The Algo 8373 can also be used to convert and expand an existing single zone paging system into a multiple zone paging system using extension plus zone dialing, direct sip extension, or multicast zone. When used as a hybrid voice paging solution, the Algo 8373 can integrate the analog speaker infrastructure along with other multicast SIP endpoints. Includes the screw terminal block plugs. The installer should be familiar with configuration and programming of Voice over IP devices and analog paging system zone mapping. Requires Power over Ethernet. If PoE is not available, use PoE Injector. Does not support direct power connection - PoE Only. See manufacturer's website for specifications, new features, and required firmware updates.
PAC SNI15 Line Output Converter for Adding Amplifier
SNI-15 converts 10 to 30 watts per channel with a fixed 10:1 conversion, linear from 20 - 20,000 Hz at +/- 5 dB, while maintaining signal phase. Isolates input and output circuits to prevent ground loop noise. Perfect when adding an amplifier to a factory or aftermarket radio. Great for getting an additional set of pre-amps outputs from a head unit equipped with only one set.
CyberData 011146 VoIP/SIP Paging Server with Bell Scheduler
- Supports 600 Ohm output- Page start relay contacts- Remote amp fault sensor- SIP RFC 3261 compatible- Multicast output- Two SIP endpoints (one for Night Ringer)- DTMF control of zone selection- Delayed Page Support- Line-In connection for music- Line-out connection to support analog Amps
- Viking universal paging interface- Select: FXO (loop start) FXS (ring trip) or paging port (VOX relay) interface mode- No power supply required in FXS interface mode- Up to 6 units can be powered from one adapter in the FXO or VOX mod
Tips to find the best prices on Paging Adapter. Always take into consideration specials, rebates or other savings, including shipping, handling and taxes. aDealaLot Search Engine will always search for these offers, including the total cost, and provide you with the best price. New products, merchants and services are always being added to help you save time and money. Compare prices, read reviews on products and merchants and find specials not offered anywhere else.
Multicast Paging with CyberData VoIP Paging Server
In this video, I give an overview of multicast paging vs. standard paging, and go over the interface of the CyberData VoIP v3 Paging Server.
Amazon Affiliate link to this product:
CyberData VoIP V3 Paging Server: http://amzn.to/2lIOp7N
Wikipedia article on multicast addressing: https://en.wikipedia.org/wiki/Multicast_address
Chris Sherwood with Crosstalk Solutions is available for best practice network, WiFi, VoIP, and PBX consulting services. Visit http://CrosstalkSolutions.com for de...